INSTALLATION WALKTHROUGH:
5. Raise the hitch into position, thread the fishwires into the
mounting holes. On the bottom attachments, place a
CM-SP10 spacer on the bolt and loosely install all 1/2" hex
flange nuts with a 3/4" socket.
Trailhawk Models:
Raise hitch and loosely install factory M14
hardware removed in Step 1.
6. Torque all 1/2" hardware to 110 ft.-lbs or M14 hardware to
135 ft.-lbs. Reinstall access panel and plastic screws
removed in Step 3.
4. Fishwire (2) 1/2" carriage bolts and (2) CM-SP10's into the
holes on the outside of each frame rail. Reverse Fishwire
(1) 1/2" carriage bolt and (1) CM-SP10 into the hole on the
bottom of each frame rail. Keep fishwires attached until
hitch is raised into position.
3. Clear away caulk as necessary near mounting holes using
a utility knife. On the passenger side, remove (2) plastic
screws retaining an access panel located in the wheel well
using an offset phillips screwdriver. Save for reinstallation.
Note
: Removal of the rear wheels may ease installation.
Summary of Contents for 13269
Page 4: ......
