GB-13
Bef
or
e
U
se
Oper
ation
Cleaning
and
M
ain
tenanc
e
Specifica
tion
Saf
et
y
W
ar
nings
Starting a Wash Cycle
Please follow the steps below to start a wash cycle.
1. Ensure the unit is connected to the mains power and the water supply is fully opened (water pressure
between 0.04MPa and 1.00MPa).
2. Open the door. Pull out the dishwasher basket, load the dishes and push the baskets back.
3. Pour in the detergent in the detergent slot or place the 3 in 1 detergent tablet in the detergent tablet
basket.
4. Close the dishwasher door. Do not slam the door.
5. Press
On/Off
button.
6. Select the wash cycle programme based on the loading and soil requirements. Please refer to the “Wash
Cycle Table” (page 12).
7. The power indicator light and the selected programme indicator light will illuminate.
8. Press the
Start/Reset
button and the washing cycle will begin shortly.
•
If you open the dishwasher’s door during the washing cycle and then close it, the
dishwasher will continue the current washing programme after a few seconds.
At the End of a Programme
At the end of the programme, the dishwasher will sound.
Switching off the Dishwasher
For energy saving, please remember to switch the dishwasher off using the
On/Off
button. The dishwasher
will continue to use electricity until it is switched off with the
On/Off
button.
•
If the dishwasher is not going to be used for a long period of time, e.g. on holiday, please
disconnect the dishwasher from the mains supply.
Unloading the Dishwasher
Allowing dishes to cool down before unloading is important because dishes tend to break and chip more
easily when they are hot. Therefore, if you open the dishwasher door fully after switching off this will allow
the dishes to cool down much faster.
Currys Essentials CDWTT10_IB_100413.indd 13
4/13/10 5:10 PM