22
9. You are now ready to pull cable. Refer to Model 88 Cable Puller
instructions on pages 30 – 39.
10. If more reach is required, both sets of factory supplied boom tubes
may be replaced with up to 10’ lengths of 2” rigid conduit or 2”
schedule 40 Pipe. Only use 2” rigid conduit or 2” schedule 40 pipe
for boom tubes. Never substitute any other size or type of conduit
or pipe for boom tubes. Never replace factory supplied boom tubes
with shorter boom tubes. Boom tubes in each set must be of equal
length. See WARNING below.
DO NOT allow the cable puller and boom to hang from slip-in or screw-on
couplings. The couplings may break causing injury. The mobile carriage or
T-stand should support the weight of the cable puller.
CAUTION
When using one set of boom tubes and nose unit, factory supplied boom tubes may be replaced but
must meet the following specifications:
• 4' minimum to 10' maximum
• only use 2" schedule 40 pipe or 2" rigid conduit
• these two tubes must be equal in length
When using elbow unit, nose unit and both sets of boom tubes, factory supplied boom tubes may be
replaced but must meet the following specifications:
• 4' minimum to 10' maximum
• 3' minimum to 10' maximum
•
• only use 2" schedule 40 pipe or
2" rigid conduit
2" rigid conduit
• these two tubes must be
• these two tubes must be
equal in length
equal in length
4' min. to 10' max.
4' min. to 10' max.
3' min. to 10' max.
WARNING
ASSEMBLY INSTRUCTIONS
continued . . .
