LOOP OUTPUT
The amp does not have a loop output. If a loop output is needed to gang
an amplifier to obtain more zones of music or used as a source for other
components use a dual Y output RCA plug
.
See figure to the right.
INSTALLATION
Setup Selections
SELECTING INPUTS
Caution:
Before making any changes to the Bridged switch position insure that the Master
Power switch on the rear of the amp is OFF. Possible damage to the amp may occur due
high transient current during switching or from wiring misconfiguration.
Line In
This is the source for each channel.
Bridge/Mono Switch
In certain instances the user may require addition power for some applications. 300 watts of
mono at 8 ohms may be obtained. When in the Bridged mode you are combining the two
channels to accomplish the increased power. NOTE: You will require two amps to get the
increased power for stereo.
Caution:
Make sure the Master Power switch is OFF before making changes.
Connect the (-) speaker wire to the top left RED binding post. Connect the (+) speaker wire
to the top right RED binding post. Even though it may appear wrong this is correct. Check
your work. If you require stereo you will require another AMP-2150. Designate one of the
amps as LEFT and the other amp as the RIGHT channel.
Caution: DO NOT connect more than one speaker to the output in the Bridge mode.
Maintain a 8 ohm minimum load when using the Bridge mode.
8
Move switch to Bridged
Mono mode, with
Master Power Off
(-) Speaker Lead to R+
(+) Speaker Lead to L+
Bridge Mode Hook-up
www.currentaudio.com
©2013 Current Audio LLC
1890 Cordell Court, Suite 105 El Cajon, CA 92020 Sales 866-927-7181
AMP2150 RPA 11152013
Not Used in Bridged Mode
Dual Y RCA Plug
