16
VLC-4 rev.02
VLC-4
8.
MEMORY CARD
The memory card is used to create a backup
copy of your controller’s configuration. The
card is also useful to transfer the configura-
tion of one controller to another controller of
the same type.
The switch at the bottom of the card is used
to lock or to unlock the card ( = locked,
= unlocked).
Turn off power each time you open the
controller's enclosure. This prevents
accidental exposure to areas of high
voltage.
Memory Card
Card Switch
Connector
Electronic
Board
To transfer a configuration:
3. Turn off power to the controller.
4. Open the latch and lift the controller's
cover.
5. If you are about to copy the controller's
configuration on the memory card, make
sure the card's switch is at the unlocked
position.
6. Insert the card in the J9 connector located
on the electronic board inside the controller.
Components of the memory card must face
down as illustrated.
7. Close the cover then reapply power to
the controller. The transfer menu should
be shown on screen (if this is not the case,
simultaneously press the MENU SELECT
up- and down-arrow keys for 3 seconds to
display this menu).
8. Use the up- and down-arrow keys to select
the proper type of transfer:
Memory card to controller:
To transfer the memory card's content into
the controller, select the
"Mem.Card –>
Ctrl"
.
Once it is selected, simultaneously
press the ADJUSTMENT BUTTON up and
down-arrow key to start the transfer.
Mem.Card –> Ctrl
to start
Controller to memory card:
To save the controller's configuration into the
memory card, select the
"Ctrl –> Mem. Card"
menu. Once it is selected, simultaneously
press the ADJUSTMENT BUTTON up and
down-arrow key to start the transfer.
Ctrl –> Mem.Card
to start
9
VLC-4 rev.02
VLC-4
5.3. Installation Options
The following section describes how to
customize the controller for your particular
application. This setup generally needs to be
performed only once.
1. Select the following menu items:
» USER SETUP
» 2. Installation*
* This menu is only available from the installer
mode (s.5.2).
Installation
Nb Program 10
Contrast 100
Time Mode AM/PM
Installer Password
Code #1 6
Code #2 1
Code #3 0
2. Set the following parameters:
Number of light programs —
Select the proper
number of light programs. Adjustable from 1
to 10 programs. *
Refer to section 6.1 for further
information about these programs.
Contrast — Select the LCD screen's appro-
priate contrast level. Adjustable from 10 to
100%.
Time Mode — Select the desired time format
(AM/PM or 24 hours).
5.4.
Version
This menu shows the version number of your
controller program. This piece of information
is useful to get technical support.
1. Select the following menu items:
» USER SETUP
» 2. Installation
» 4. Version
VLC-4 Vx.x
Vx.x PC.xx
