Cumberland SPRKT2415, Operation And Installation Manual

Page: 9 / 34

PNEG-881 Curtain Controller 9
3. Installation
This manual outlines the recommended sequence for the installation of the Curtain Controller System.
Following the sequence will prove the safest and easiest method of installation. Above all, connection of
the system to the electrical mains should be final stage of installation. Failure to observe this could lead
to a fatal accident.
1. Unpack the Curtain Controller and remove the front cover. Inspect the machine for visible defects.
2. Select mounting configuration. (See examples of: Outside sidewall one (1) curtain, outside endwall
two (2) curtains and inside endwall two (2) curtains on Page 27-30 .)
3. Screw one (1) 3/8" x 3" lag bolt 6-1/2" below the desired height of the Curtain Controller.
NOTE: Leave 1-1/2" between the bolt head and the wall. (See Figure 3A.)
Figure 3A
4. Using the “keyhole” slot in the back of the Curtain Controller, hang the machine on the 3" lag bolt.
(See Figure 3B.) NOTE: The 3" lag bolt should only be used to hang the machine to the wall. Do
not attempt to operate the machine until it is fully secured .
Figure 3B