Super Saver Bunsen Jet Brooder with SPI
4
All controls are located on the gas valve mounted on top of the brooder canopy. There are three
controls you will use: the control knob, pilot purge button, and the thermostat knob, see
illustration below. The control knob is located on the back side of the gas valve and has three
positions: ON, OFF, and PILOT. The pilot purge button is the spring loaded red button located
beside the control knob. The thermostat knob is located on top of the gas valve, and is adjustable
from 1 (Low) to 9 (High).
5.
Assembly
5.1.
Tools Required
Wire pliers
1/2” wrench
7/16” wrench
11/32” nut driver
Phillips screwdriver
Gas leak testing solution
Pipe thread sealing compound
5.2.
Support Ring Assembly
1.
For support ring assembly, see Figure 2, then follow these steps.
2.
Insert one suspension rod through each of the openings in the outside of the support
ring. The suspension rod will slide through the opening until the swaged portion
located on the middle section of the bracket is reached.
Pilot Purge Button
Gas Outlet
To Pilot
Gas Inlet
Thermostat
Control Knob
To Thermocouple
Figure 2
Support Ring Assembly
Support Ring
Suspension Rod
Figure 1
Gas Valve
