3. Installation
4802-0103
Curt-O-Matic Installation
11
Outside
Winch mounted on the outside corner of the building:
If this setup is used with a Power-Trak, the Curt-O-Matic should be mounted on the lower U-bolt on the
corner bracket while using the handle J-Hook (10).
Otherwise, mount the unit above
winch in a convenient location.
Place flat washers (18) on both sides of the winch release lever and mount with screw. Secure in place
although DO NOT OVER TIGHTEN. Lever must rotate freely and without obstruction.
Figure 3B Assembly Components
Chain Adjustment Kit
Fasten the spring hook (or Quick-Link) to the curtain cable with the cable clamp (12). Secure one end of
the chain to the building with the lag screw. Chain can be connected to the spring hook (10) to preset drop.
This will restrict how far the curtain will fall.
NOTES:
•
The curtain fall distance depends on the system setup and Quick-Link location. Set the
Quick-Link location as necessary to accommodate the proper curtain position when the
Curt-O-Matic is activated/curtains lowered.
•
Verify that the winch or winch handle can not become tangled with the cable and/or chain.
Relocate the cable or chain if necessary.
•
Test the setup when installation is complete to ensure proper curtain drop distance and
operation without interference with the winch or winch handle.
Make sure there are no obstructions around arm.
Ref #
Description
7
Cable Loop in Load Slot
8
Galvanized Cable
9
Crimp Sleeve
10
Handle J-Hook
11
Release Lever
18
Flat Washers
