16
Culligan® High Efficiency 1.5 Twin Water Softener
16
Cat. No. 01024821
Brine System Installation
NOTE The brine system is purchased as an optional item to allow the use of various brine tank sizes to better
suit the needs of the user.
The softener system is normally regenerated using a timed brine refill, dry or wet salt storage brine system. To properly
install the brine system, set the brine tank assembly in a convenient location for ease of service and refill of salt into the
brine tank.
Brine Piping
The softeners can be used with a variety of brine systems. Please refer to
Position the salt storage tank in a convenient location on a smooth surface. The brine valve should be at the rear to sim-
plify removal of the tank cover.
If multiple softeners will be drawing brine from the same tank, connect the brine tubing from the brine fitting on each valve
to a union tee. (P/N 00401574, supplied with small parts pack)
To Brine Line Adapter
Fitting Softener Unit
Duplex Tee
Polypro.
Insert
Nut Tubing
To Brine Line Adapter
Fitting Softener Unit
Tubing
Nut- Plastic
Polypro. Insert
Brine Chamber
Cut 1/2” tubing (not supplied) sufficient to reach control using
brine fitting.
Brine Valve
Adjust float assembly to be just below the overflow fitting as a secondary
shut-off to the timed refill function of the GBE controller
Brine Connection Tubing
NOTE Culligan recommends routing the overflow
to the drain line or a floor drain to prevent
damage to the facility.
