10
Brewing
1. Remove water reservoir to fill.
2. Add water into the 40-ounce (1.2 L) water
reservoir. Replace on unit.
3. Press the Power button.
4. The Power and Brew buttons will
illuminate.
5. Place mug on the drip tray. The drip
tray can be removed to accommodate
travel mugs.
6. Select a capsule.
Note:
Do not remove the foil lid or
puncture the capsule.
7. Open the brew head and place a capsule
in the brewing chamber.
Caution: There are two sharp
needles in the brewing chamber
that puncture the capsule, one
above and one below. To avoid risk
of injury, do not put your fingers in
the capsule brewing chamber.
8. Press the desired brew button
(6, 8, or 10 oz.). The beverage will start to
dispense momentarily. Selected brew
button will flash while brewing.
Note:
To cancel brewing, simply press the
selected brew size once again and the
brewing process will be stopped.
Caution: There is very hot water in
the capsule chamber during the
brewing process. To avoid risk of
injury, do not lift the handle or open
the capsule chamber or remove
water tank during the brewing
process.
9. Once fully dispensed, all lights will
illuminate. Lift the handle, then remove
and dispose of the used capsule.
Close the brewing head.
Caution: Capsule will be hot.
10. Enjoy your cup of coffee! Your brewer
is ready to use again or you can power it
off.
Note
: When Add Water LED starts to
flash, no brewing can be done. Once you
refill the reservoir, your unit is ready to
brew.
