5.6 Match lighting
IMPORTANT!
A match lighting hole is located on the left side of the firebox.
Match lighting instructions:
1. Read all instructions before lighting.
2. Open lid during lighting.
3. Make sure the gas control knob is in “OFF” position.
4. Strike a long wooden match and position the burning match through the match
lighting hole in the firebox bottom. Place the flame near the bottom edge of the burner.
5. Push down and turn the burner control knob counter-clockwise to the high setting.
6. The burner should light. The flame will carry around the burner. Allow grill to pre-heat with the grill lid closed
for 2-3 minutes before cooking.
m
CAUTION:
Do not touch any hot grill parts. The outside of the grill bottom especially becomes
very hot during use. Use protective gloves to handle any parts that might become
hot during use.
5.7 Using the Grill
Inspect the burner flame by looking through the match lighting holes.
A good flame should be blue with some yellow tips coming from the burner holes.
Yellow tips on flames up to 1/4“ in height are acceptable as long as no carbon or
soot deposits appear.
During operation, stand to side of grill when opening the grill lid.
Do not expose any part of your body directly above the
cooking area.
The burner opening must be positioned properly over the
valve orifices.
10
6. Care And Maintenance (cont.)
6.3 Cleaning And Maintenance
WARNING: Do not clean any grill surface while grill is operating.
Let grill cool to a safe temperature prior to cleaning.
• Disconnect the fuel supply and remove the fuel supply cylinder prior to cleaning.
• Cleaning should be done where detergent won’t harm work surface or lawn.
Exterior Cleaning
• Clean grill exterior surfaces with warm soapy water.
• Wash drip tray in warm soapy water – do not run through dishwasher.
Interior Cleaning
• Cooking grate can be cleaned with a grill brush. For best results, cooking grate should be warm (warm, not hot – never
brush with grill operating, or when interior is very hot). If desired, cool cooking grate can be removed from grill and
cleaned with warm soapy water.
• Should you wish to remove accumulated debris from the bottom of the fire box, proceed as follows:
– Let grill cool completely
– Remove cooking grate and set aside
– Remove flame tamer and set aside !CAUTION Flame tamer edges and surface are sharp – use care when handling
– Carefully scrape and remove debris from bottom of firebox using care not to touch burner element, igniter, or igniter wire.
WARNING: DO NOT APPLY ANY CLEANERS OR LIQUIDS TO BURNER ELEMENT
OR ATTEMPT TO CLEAN IN ANY WAY.
–
DO NOT USE WATER OR LIQUIDS TO CLEAN GRILL INTERIOR
– Replace flame tamer and securing screw.
CAUTION: DO NOT OPERATE GRILL WITHOUT FLAME TAMER IN
PLACE.
7. Frequently Asked Questions
• CAN I USE A 20LB LP TANK?
You may use a standard 20 lb. LP tank with your Cuisinart Gas Grill, but you will need a conversion hose, such as the
Cuisinart QG-012B or equivalent. These hoses are widely available online, and at most home centers and hardware
stores. [be sure the 20 lb tank you are planning to use is intended for gas grill use, and has an OPD valve]
• CAN I USE MY CUISINART GAS GRILL WITH NATURAL GAS?
NO. Your Cuisinart Gas Grill is intended for use only with LP (Liquid Propane) gas. Natural Gas is NOT Liquid Propane.
Never use any other fuel source with your grill, as it will create a dangerous situation.
• CAN I ADD LAVA ROCKS, CERAMIC TILES, OR CHARCOAL BRIQUETTES TO MY CUISINART GAS GRILL?
NO. Your grill is not intended to operate with these items, and doing so may create an unsafe situation, and will void
your warranty. You may use wood planks or a wood chip “smoker box” on top of the cooking grate surface, but
nothing should go under the cooking grate.
• CAN I BUY ACCESSORIES FOR MY GRILL OVER THE PHONE?
Yes, you can call 1-800-211-9604 for assistance.
8. Troubleshooting
BURNER WON’T LIGHT (USING A 16.4OZ OR 14.1OZ LP BOTTLE)
• Be sure LP bottle still has fuel in it by gently shaking it - there will be sounds of liquid inside if fuel remains.
• Check to see that the venturi tube air inlet screen is not covered or clogged (see users manual).
• Check to see that burner orafice holes are clear. If obstructed, with gas bottle disconnected, gently brush orafice holes
with a small brush.
• Check to see that ignitor is producing a spark against the burner (best checked in shady spot).
If above do not solve problem, unless LP tank is new, replace with new tank and attempt lighting again.
6. Care And Maintenance
6.1 Care
Regular care of your grill will help keep it operating properly. All maintenance should be done only when the grill is cool
and with the fuel supply turned off. Occasionally inspect and tighten hardware that may become loose.
6.2 Cleaning The Venturi Tube
A spider’s nest or wasp’s mud inside the Venturi can block gas flow and can even cause a fire at the gas control valve.
Such a fire can cause operator injury and serious damage to your grill.
To prevent insect related problems, inspect the Venturi tube screen cover regularly and remove any dirt.
WARNING!
Do not disassemble or alter the fuel supply system. Improper assembly can result in a hazardous condition. Seek quali-
fied professional assistance if repairs are required.
11
5. Operating Your Grill (cont.)
