7
5. Remove the pulp container from the side of the motor base and empty.
COMPACT JUICE
EXTRACTOR OPERATION
1. Make sure your Juice Extractor Attachment is properly assembled
(see Page 6) and attached to the motor base.
2. Plug the power cord into the 120V electrical outlet.
3. Wash all selected fruits or vegetables.
4. While many fruits and vegetables will not need cutting, any item
with a diameter larger than 2 inches will need to be cut.
5. Turn the dial from the STOP position to HIGH.
6. Lift the food pusher out of the feed tube and drop your food
into the opening. Push through by inserting the food pusher
and pressing firmly. Do not pack the feed tube too full of food.
Be sure that the food has been processed through the filter basket/
blade before adding more items.
Note:
When using leafy vegetables with stems, please put the leafy
end into the feed tube first followed by the stem. Do not over pack
feed tube.
7. The juice will flow into your glass and the pulp will accumulate
in the pulp container.
8. When finished juicing, turn the dial to the STOP position to stop
the motor.
COMPACT BLENDER AND
JUICE EXTRACTOR COMBO
CLEANING AND MAINTENANCE
Always unplug your Cuisinart
®
Compact Blender and Juice Extractor
Combo from the electrical outlet before cleaning. The base and parts are
made of corrosion-resistant materials that are easy to clean. Before first
use and after every use, clean each part thoroughly. Periodically check all
parts before reassembly.
DO NOT USE IF ANY PART IS DAMAGED,
OR IF THE BLENDER CUP IS CHIPPED OR CRACKED.
To remove blade assembly, twist off by turning clockwise.
NEVER TOUCH THE BLADE.
CAUTION:
Handle the blade assembly carefully. Blades are SHARP
and may cause injury. DO NOT attempt to remove blades from cutting
assembly, do not attempt to detach the blade assembly from Blade collar.
Wash all parts in warm, soapy water. Rinse and dry thoroughly. All parts
are top rack dishwasher safe.
Tip:
You may wish to clean your blade assembly cutting assemblies as
follows: Squirt a small amount of dishwashing liquid into blending cup and
fill halfway with warm (not hot) water. Attach blade assembly and run on
Low for 15 seconds. Repeat, using clean tap water. Carefully disassemble
parts and empty blending cup. Rinse and dry all parts thoroughly.
Finally, wipe the motor base clean with a damp cloth to remove any
residue, and dry thoroughly. Never submerge the motor base in water
or other liquids, or place in a dishwasher.
Any other servicing should be performed by an authorized service
representative.
