12
Leak Check Instructions
1. Make 2-3 oz. (60-90 ml) of leak-test solution by
mixing one part liquid dishwashing soap with
three parts water.
2. Make sure control knob is in “OFF” position.
3. Spray or paint some leak solution on cylinder
and regulator connection.
4. Inspect solution at the connections, looking for
bubbles. If no bubbles appear, connection is
secure.
5. If bubbles appear, a leak is detected. Go to step
6.
6. Disconnect cylinder from regulator and
reconnect. Make sure connection is secure and
no leak is found before using the grill.
7. If you continue to see bubbles,
DO NOT USE THE GRILL
. Repeat above process with a
different LP cylinder. If leaks are still present, contact the customer service centre.
5.5 Lighting instructions
1. Read all instructions before lighting.
2. Open lid during lighting.
3. Make sure gas control knob is in “OFF” position.
4. Unfold side tables into open position.
5. Push gas control knob and quickly turn counter-clockwise to
“HIGH” position. The igniter will click and light the burner.
6. If ignition does not occur in 5 seconds, turn gas control knob off,
wait 5 minutes, and repeat steps 2-5.
*Before cooking on grill for the first time, operate grill for about 15 minutes with lid closed and gas
turned on “HIGH”. This will “heat clean” the internal parts and dissipate odour from the painted
finish.
*Clean grill after each use. DO NOT use abrasive or flammable cleaners, as they will damage the
product parts and may start a fire. Clean with warm soapy water.
If burner does not light, turn gas control knob off and wait 5 minutes to let gas clear before you try
again. (
Please see 5.3 Installing the gas cylinder)
5.6 Match lighting
IMPORTANT!
A match lighting hole is located on the left side of the firebox as shown below.
