Cuckoo NO.1, Manual

Page: 11 / 84

HOW TO CLEAN
1 1
www.cuckooworld.com
ENGLISH
2. To close the lid turn the handle to unlock,
in shown in the picture on the right.
1. Check to make sure the inner pot is
place correctly inside the main body.
3. If there is excess steam inside the
inner pot it might be difficult to lock
the handle. Twist the pressure
weight and allow the excess steam
to release. Then try to turn the
handle again.
Do not try to close the lid by force. It can cause problems.
When lid does not close perfectly
❷ Separate cover as
the arrow points.
❸ Use brush kit. You can easily
clean a drain use the ditch
cap and tough pat to clean. ❹ When using cleaning
pin, pull out cleaning
pin and make it meet
at right angles.
❺ Only use for the
vlave hole of the
pressure weight.
❶ Separate cleaning pin Attached
on the bottem of the unit from
main body as shown in picture.
How to use cleaning pin and brush kit
❶ Separate dew dish ❷ Separate the drain ditch
cap by pushing it down.
❸ Clean the drain ditch
cap and dew dish with
a neutral detergent. ❹ Clean the drain ditch
cap with brush kit.
❺ Securely put in the dew
dish after cleaning.
How to clean dew dish
How to clean the soft steam cap
※ Do not touch the surface of the soft steam cap right after cooking. You can get burned.
❶ Detach the soft
steam cap like the
picture. ❷ Press the hook in the back, and follow the
arrow to detach and clean. Make sure you
clean frequently with a sponge or a neutral
detergent.
❸ Assemble the went so that it fits into
the groove perfectly. ❹ After you attach the soft
steam cap to fit into the
groove, press “A” part
firmly to assemble the soft
steam cap into the product.
How to clean the pressure weight nozzle.
The valve hole of the pressure weight allows steam to release. Check regularly to ensure that it not blocked.
If the valve hole of the pressure weight is blocked, the hot steam and hot content within the cooker can
cause serious injury.
※
Do not use the cleaning pin for any other use except to clean the valve hole of the pressure weight.
Soft steam cap
Cleaning Pin
If the valve of the pressure part is clogged, puncture it with the cleaning pin
How to
disassemble the
pressure weight
▶ Under the Lock/Unlock handle is locked(located on “Lock”) turn the pressure weight counter-
clockwise while pulling it up, and pull it out.
▶
Puncture the clogged valve hole with the cleaning pin and reassemble it by turning it clockwise.
▶
When the pressure weight is properly assembled, it can freely be turned.
Pressure Weight
※ Attached on the
botton of the unit.
Alien
Substance
packing
LOCK LOCK
❶ ❷ ❸