Cuckoo CBT-I1030RW, User Manual

Page: 31 / 64

31
HOW TO CLEAN
www.cukooamerica.com
• Use of a sharp brush or a coarse dishwashing sponge for cleaning may cause scratches and/or damage to the product.
• Do not use sharp brushes or coarse dishwashing sponges to clean the bidet in order to prevent scratches or
damage to the product.
• Refrain from spraying water on the nozzle and hot air inlet as this may cause electrical shock or product malfunction.
• Do not use a dishwashing sponge, benzene, thinner or other harmful detergents when cleaning the control panel.
Always ensure the power plug is removed from the outlet before attempting to clean.
Cleaning Precautions
How to Clean the Nozzle
How to Clean & Replace Nozzle Cap (CBT-I1030RW)
Automatic nozzle cleaning
• While you are not seated on the seat, press the "NOZZLE CLEANING" button briefly.
• The nozzle automatically moves back and forth for automatic cleaning.
The nozzle will automatically move back and forth for automatic cleaning
While you are not seated on the seat, press and hold the "NOZZLE CLEANING" button for 3 seconds.
The manual function will be activated to protrude the nozzle.
• Clean the nozzle with a toothbrush, etc. you do not use.
• Once the STOP button is pressed or 2 minutes elapses,
the nozzle goes in for self-cleaning.
(Manual nozzle cleaning) If you press and hold the "NOZZLE CLEANING" button without sitting on the seat,
the nozzle moves forward and stops for 2 minutes.
At this time, take out the nozzle cap and use a toothbrush, etc. to clean both the nozzle and nozzle cap.
The nozzle cap will be separated from the nozzle if you press both of its ends and the nozzle downward in the
vertical direction and then pull the cap slightly in the horizontal direction of the nozzle.
After cleaning, insert the nozzle cap and press the STOP button to return the nozzle.
Press both ends of the nozzle cap and the
nozzle downward in the vertical direction.
While pressing them down, pull the cap
in the horizontal direction of the nozzle.
Pushing the nozzle in by force without pressing the STOP button may damage the nozzle.
If you pull the nozzle cap by force, the hook located on the rear of the nozzle cap may be damaged.