26
Note:
1. Dump mode requires 4” wide paper.
2. Cycle the power to resume normal printing.
3. Press FEED button to go back to the previous menu.
4.3.3 Printer Initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults. The
only exception is ribbon sensitivity, which will not be restored to default.
Printer initialization is activated by the following procedures.
1. Turn off the power switch.
2.
Press and hold the FEED button while powering on the printer.
3. Release the
FEED
button when LED
is blinking
green
.
(
The LED will blink
green
5 times. You may release the feed button at any point while blinking green)
.
green (5 blinks)
Æ
green/amber (5
blinks)
Æ
red/amber (5 blinks)
Æ
solid green
Printer configuration will be restore to defaults as below after initialization.
The LED color will change
in the
following
order
:
Amber
Æ
red (5 blinks)
Æ
amber (5 blinks)
Æ
Parameter
Default setting
Speed
127 mm/sec (5 ips) (203DPI)
76 mm/sec (3 ips) (300DPI)
Density 8
Label Width
4” (101.5 mm)
Label Height
4” (101.5 mm)
Sensor Type
Gap sensor
Gap Setting
0.12” (3.0 mm)
Print Direction
0
Reference Point
0,0 (upper left corner)
Offset 0
Tear Mode
On
Peel off Mode
Off
Cutter
Off
Mode
Serial Port Settings
its, 1 stop bit
9600 bps, none parity, 8 data b
Code Page
850
Country Code
1
00
Clear Flash Memory
No
IP Address
DHCP
