13. Make sure all air bubbles are removed from under the
label.
14. Reach up inside the right hand pod and install the
wire harness connector to the Bluetooth
®
enabled main-
tenance meter. Confirm that the wire harness connector
snapped in place.
15. Connect the positive battery cable to the positive bat-
tery terminal, then connect the negative battery cable to
the negative battery terminal.
16. Turn the key to the on position, the new Bluetooth
®
enabled maintenance meter display should show the
hours.
17. Start the rider and confirm the Bluetooth
®
enabled
maintenance meter is functioning correctly.
NOTE: Connect the Bluetooth
®
enabled maintenance
meter to your smartphone by downloading the Cub
Connect
™
App for your Bluetooth
®
capable Android
or iOS device. See Page 9 for instructions.
12. Install Item #3 (
777I25406
) RZT Bluetooth
®
enabled
maintenance meter label. Carefully align the label over
the maintenance meter so that the open rectangular sec-
tion is centered over the silver rectangular LCD display
and the left side of the label is aligned with the edge of
the throttle /choke control slot. See Figure 7.
Optional Kit 490-900-C066 3 of 9 Form No. 769-10822 /00
FIGURE 7
Item #3
(777I25406)
FIGURE 6
Remove Rectangular Section
Item #3
(777I25406)