Optional Kit 490-900-C066 2 of 9 Form No. 769-10822 /00
RZT Installation Instructions:
1. Park the rider on a flat level surface. Engage the park-
ing brake. Lower deck to lowest position.
2. Disconnect the negative battery cable from the nega-
tive battery terminal, then disconnect the positive battery
cable from the positive battery terminal.
3. Allow the unit to cool to ambient temperature before
proceeding.
4. Reach up inside of the right hand pod and disconnect
the main wire harness connector from the maintenance
meter by depressing the tab and pulling the connector
down. See Figure 2.
8. Make sure the top surface of the right hand pod is free
of the old label, dirt, etc. Clean as needed.
9. Install Item #1 (
725-06221
) Bluetooth
®
enabled Mainte-
nance meter in the square opening as shown In Figure 5.
NOTE: The terminal block must be at the bottom,
above the PTO switch as shown in Figure 5.
FIGURE 2
5. Carefully peel/remove the existing maintenance meter
label away from the pod and top of the maintenance
meter. See Figure 3.
FIGURE 3
6. Reach up inside of the right hand pod and squeeze the
two (2) tabs inward to release the maintenance meter
from the right hand pod.
7. Push the maintenance meter out the top of the right
hand pod. See Figure 4. Discard the maintenance meter.
Remove Label
FIGURE 4
FIGURE 5
Terminal Block
Item #1
(725-06221)
Tab
Tab
Wire Harness
Connector
Depress Tab
Right Hand Pod
10. Push the Bluetooth
®
enabled maintenance meter all
the way into the right hand pod until the two (2) tabs snap
in place.
11. Remove the black rectangular section from the center
of Item #3 (
777I25406
) RZT Bluetooth
®
enabled mainte-
nance meter label as shown in Figure 6 and discard.
Maintenance Meter