CTS HES-3109 Series, User Manual

Page: 31 / 50

31
2.5.10 SNMP-Server command
1. Create a SNMP community and set up detailed configurations for this community.
Snmp-server command Parameter Description
Switch(config)# snmp-
server community
[community] [community] Specify a SNMP community name of up to
20 alphanumeric characters.
Switch(config-community-
NAME)# active Enable this SNMP community account.
Switch(config-community-
NAME)# description
[Description] [Description] Enter the description for this SNMP
community of up to 35 alphanumerical
characters.
Switch(config-community-
NAME)# level [admin | rw |
ro] [admin | rw |
ro] Specify the access privilege for this SNMP
account. By default, when you create a
community, the access privilege for this
account is set to “read only”.
admin: Full access right includes
maintaining user account, system
information, loading factory settings, etc.
rw: Read & Write access privilege. Full
access right but cannot modify system
information, user account, load factory
settings and upgrade firmware.
ro:
Read Only access privilege. Allow to
view only.
No command
Switch(config)# no snmp-
server community
[community] [community] Delete the specified community.
Switch(config-community-NAME)# no active Disable this SNMP community account.
Switch(config-community-NAME)# no
description Remove the entered SNMP community
descriptions.
Switch(config-community-NAME)# no level Remove the configured level. This will set
this community’s level to read only.
Show command
Switch(config)# show snmp-
server community
[community] [community] Show the specified SNMP server account’s
settings.
Switch(config)# show snmp-server
community Show SNMP community account’s
information in Global Configuration mode.
Switch(config-community-NAME)# show View or verify the configured SNMP
community account’s information.