13
Installation – Settings
DIP 9: Autoconnect
Fifteen minutes after turning the
cooker off, the cooker guard will
automatically be reset and turn
the power back on. On a cooker
with rotary switches, all the rings
and oven must be turned off before the cooker guard will reset itself
automatically.
If this function is deactivated or to reset the cooker guard manually, press
the control button on the sensor (or external switch panel, optional extra).
There are three different function tests:
1 = On/Off test 2 = Current test
3 = Temp. test
To activate the function test:
1. Remove the SENSOR cover and set DIP switch 0 to ON
2. Put the cover back on temporarily to stop the batteries falling out.
To change between the three function tests, hold the control button on the
sensor in for 5 seconds. The sensor acknowledges with one, two or three
beeps to indicate the test type.
1 beep
On/Off test
The sensor acts as an ON/OFF switch.
Pressing the control button switches between turning the power to
the cooker ON/OFF. The light on the sensor comes on when the cooker
socket is on (sending power to the cooker).
2 beeps
Current test
Indicates electricity consumption
for the hob.
Following activation turn the hob
on. A few seconds later the LED
on the SENSOR should come on
continuously and the green and
yellow LEDs on the SOCKET should
light up.
Now turn the hob OFF. The LED on
the SENSOR goes out and only the
GREEN LED on the SOCKET should
be on.
DIP 0
Test mode
De-
fault
OFF
ON
Test mode on
DIP 0: Test mode / Function test
When you have performed the function test(s), remember to set
DIP switch 0 to OFF.
3 beeps
Temperature test
Turns the cooker on/off based on
temperature.
•
Point the sensor at a hot
surface/object. The cooker
turns off if the temperature
is over 35°C.
•
Point the temperature at
a cold surface (at normal
room temperature). The
cooker comes back on if the
temperature is below 35°C.
DIP 9
Autoconnect
De-
fault
OFF
Autoconnect off
ON
