CTC Union FRM220A-GSW/SNMP, User Manual

Page: 14 / 52

Chapter 2 Provisioning
2.2.2 Telnet Login
To enter "Telnet mode", a user ID (default is admin) is required and a password may be required. By default,
there is no password set from the factory. The user password provides security to protect the system.
CTC UNION TECHNOLOGIES CO., LTD. FRM220A-GSW/SNMP VER.[1.021]
===============================================================================
This Chassis ID:[00] Cascaded:[No ] Monitored Chassis ID:[00]
User ID:admin
Password:
After entering the correct password, you will see the main menu display on the screen as follows :
14
CTC UNION TECHNOLOGIES CO., LTD. FRM220A-GSW/SNMP VER.[1.021]
===============================================================================
Current F/W
version of GSW
This Chassis ID:[00] Cascaded:[No ] Monitored Chassis ID:[00]
No cascade function is
supported in FRM220A
<1>:SLOT #01 ------------------------ <B>:SLOT #11 ------------------------
<2>:SLOT #02 FRM220A-8E1/ET100T <C>:SLOT #12 ------------------------
<3>:SLOT #03 FRM220A-8E1/ET100T <D>:SLOT #13 ------------------------
<4>:SLOT #04 FRM220A-Eoe1 <E>:SLOT #14 ------------------------
<5>:SLOT #05 FRM220A-E1/DATA <F>:SLOT #15 ------------------------
<6>:SLOT #06 FRM220A-5E1/ET100T <G>:SLOT #16 ------------------------
<7>:SLOT #07 ------------------------ <H>:SLOT #17 ------------------------
<8>:SLOT #08 ------------------------ <I>:SLOT #18 ------------------------
<9>:SLOT #09 ------------------------ <J>:SLOT #19 ------------------------
<A>:SLOT #10 ------------------------ <K>:SLOT #20 ------------------------
<S> :System Status and Configuration
<T> :Giga Switch Status and Configuration
<U> :SNMP Status and Configuration
20 slots are available in the
FRM220A chassis for cards.
<ESC>:Logout
The inventory of all slots in the rack is shown. In this example, the chassis has a mix of iMux (5&8E1), a Eoe1
bridge card and a E1 DSU/CSU card. If no card is found in a slot, the slot status will display with 'dash marks'. The
cards are number in slots #01~#20, left to right, looking from the front of the
FRM220A-CH20 , and can be selected
with single keyin of 1~9 or A~K. Pressing the card number will immediately display card's status and configuration
screen. For details of line card settings, please refer to
Appendix A for the specific line card type. The other
function keys are explained below.
S : the 'S' key enters the System Status and Configuration screen, where additional menus for the
GSW/SNMP card's settings are configured.
T : the 'T' key will enter the Giga Switch Status and Configuration screen, where the sub menus for the L2
switch configuration can be found.
U : the ‘U’ key enters the SNMP Status and Configuration screen, where additional sub-menus are found to
setup all the SNMP parameters.
[ESC] : this key will logout of the console mode.