ZHUHAI CTC ELECTRONIC CO. LTD
DIY PRINTER INSTALLATION AND OPERATION INSTRUCTION
22
the motor coupling of A5 module and the plate below nearly 3mm, independently. As
far as possible to keep the screw rod of Z-axis and the output axis of motor on a line.
Additionally, keep the horizon distance of the screw rods of Z-axis equally from up to
down. Please adjust the Z-axis until there is no noise with the rods when each motor is
working.
5. The bundles of wires should not effect on each moving spaces and functions of
moving parts. Adjust the heat temperature according to the using environment.
6. When cleaning the printer head, please fixed the square aluminum block by using a
wrench, then, screw off the printer head. Furthermore, please avoid the tremble of the
square aluminum block which would cause the heating pipe and temperature sensor
broken when screw off the print head.
7. To enhance the adhesive forces between the printing model and the printing
platform, the glass already be stuck with masking tape before the printer leaves the
factory, consequently, please do not move the masking tape.
8.Please do not press the bottom plate heavily. When you remove the printing, use a k
nife to loosen it and slowly remove it. Do not directly remove the printing. It may cau
se deformation of the bottom plate. Customers who can't remove the printing pay atte
ntion: after the printing is completed, the printer will be cooled and the temperature of
the bottom plate will be normal temperature. At this time, the printing is stuck on the
bottom plate and it is difficult to remove it. (Do not use force to shake the printing. Th
is will cause the bottom plate to receive a lot of force from a certain point of the print
product, which may cause deformation.) Please heat the heatbed to 100 degrees to re
move the printing.
