CT Lab Vecto III, User Manual

Page: 14 / 80

Vecto III User Manual
14
2.2.1 Receiving your shipment
Upon receiving your Vecto III shipment, check the following:
•
Outside
o
Box is sealed
o
Box is not damaged
o
Box has no water damage
•
Inside
o
Vecto III in a plastic enclosure
o
Vecto III has no water damage or damp in the plastic enclosure
o
Ethernet cable, Flash drive and the screwdriver is included in the box
If the shipment is damaged or not in a working condition, please take a picture of the
damage and send the pictures to
info@ctlab.com as soon as possible. Please also
phone CT LAB on +27 (21) 880 9915 to handle the problem as soon as possible.
2.2.2 Unpacking the goods
Step Action
1 Remove all literature inside the box on top of the high-
density foam
2 Remove the accessories in the accessories cavity on the
right side of the box. Check that the standard accessories
(see section 2.2.1) are included.
3 Carefully remove the lid of the high-density foam
enclosure
4 Remove the Vecto III from the cavity and inspect for
damage
2.2.3 Checking the Battery Level
After calibration and testing, the Vecto III is switched off by means of the Power
Button. It disconnects the battery.
•
The device will not power up from the battery until mains power is
connected to the device for the first time.
When the device is connected to mains power (90-300V AC or DC) press the Power
button, check that the power LED starts to flash and that the battery charge LED is on.