CST/BERGER LASERMARK 58-iLMXL, Original Instructions Manual

Page: 19 / 320

English | 19
1 609 929 T56 • 24.2.09
Setting Up the Measuring Tool
– Position the measuring tool on a firm surface.
or
– Mount the measuring tool onto the mini laser tripod. The tripod tilts in
two directions, allowing the laser to set at any angle. (see figure B)
or
– Attach the measuring tool on a metal surface using the magnetic
mount 12 . (see figure B)
Due to the high levelling accuracy, the measuring tool reacts sensitively
to ground vibrations and position changes. Therefore, pay attention that
the position of the measuring tool is stable in order to avoid operational
interruptions due to re-levelling.
Operation
Initial Operation
f
Protect the measuring tool against moisture and direct sun
irradiation.
f
Do not subject the measuring tool to extreme temperatures
or variations in temperature.
As an example, do not leave it in
vehicles for longer periods. In case of large variations in temperature,
allow the measuring tool to adjust to the ambient temperature before
putting it into operation. In case of extreme temperatures or variations
in temperature, the accuracy of the measuring tool can be impaired.
f
Avoid heavy impact to or falling down of the measuring tool.
After severe exterior effects to the measuring tool, it is recommended
to carry out an accuracy check (see “Accuracy Check of the Meas-
uring Tool” on page 22) each time before continuing to work.
OBJ_BUCH-929-003.book Page 19 Tuesday, February 24, 2009 1:42 PM