16
MB-P201
System Memory
The motherboard uses DIMM memory. DIMM is available
in 64-pin or 72-pin, where the 72-pin DIMM provides error
correcting code (ECC).
Up to 1 GB Extended Data Out (EDO) or up to 512 MB
Synchronous DRAM (SDRAM) are supported.
Memory uses symmetrical and asymmetrical addressing.
Single and double density DIMMS are supported
There are four banks available for memory upgrades. The
board supports DIMM in the following combinations:
1M x 64/72 = 8 MB/bank
8M x 64/72 = 64 MB/bank
2M x 64/72 = 16 MB/bank
16M x 64/72 = 128 MB/bank
4M x 64/72 = 32 MB/bank
32M x 64/72 = 256 MB/bank
Installing and Removing DIMM
Read these instructions completely before installing or
removing DIMMs. The DIMM is held by plastic press-clips
on both sides of the slot.
Installing DIMM
1) Hold the DIMM so that the gold tab is pointing toward the
slot. The DIMM is keyed so that it will only snap into the
slot when positioned correctly.
2) Press one end of the DIMM until it inserts and its press-
clip snaps into place.
3) Press the other end of the DIMM until it inserts and its
press-clip snaps into place.
