Step 1: Setting Up the Demonstrator board
Step 2: Preparing the Demonstrator Board for Bluetooth Pairing
CS-110826-UGP1
© CSR plc 2006 Page 2
Step 3: Streaming Music from the PC
Note:
Before commencing, CSR recommend downloading the program
avcontrol.exe
from
www.csrsupport.com/BlueTunes
. This program allows fine control over the behaviour of the Nanosira
dongle and allows the user easily to determine the state of the device.
1.
Before inserting the Nanosira dongle into the PC, ensure
that the demonstrator board is in Bluetooth pairing mode
(see Step 2:
Preparing the Demonstrator Board for
Bluetooth Pairing
).This reduces the possibility of the dongle
pairing with any other Bluetooth device in pairing mode.
(1)
2.
Insert the Nanosira dongle into a USB port on the PC. On
first insertion the PC will display a message confirming that
it has found new hardware.
(2)
3.
The dongle automatically pairs with the demonstrator
board.
4.
Open a media player on the PC (eg.,Windows Media
Player) and play an audio/music track. The audio/music
track is streamed to the stereo headphones.
5.
Use the volume buttons (VOL- and VOL+) on the
demonstrator board to control the volume. (The device will
beep when the maximum/minimum volume is reached)
6.
Use the BACK button to rewind/go back a track. Use the
FWD button to fast forward/go forward a track. Use the
PLAY/STOP button to stop, pause and play tracks.
Notes:
(1)
If the dongle pairs with the wrong device, start the avcontrol
program. Select
Discover New Headphones
; the stored
Bluetooth address clears and the pairing process begins
again.
(2)
If required in the future, the dongle can be uninstalled from
the PC in the following way: go to Control Panel and run the
Add/Remove Hardware Wizard. Remove USB Audio
Device from the hardware list.
Step 4: Receiving a Mobile Phone Call
1.
Ensure the demonstrator board is in pairing mode
(see Step 2:
Preparing the Demonstrator Board for
Bluetooth Pairing
).
(1)
2.
Go to the Bluetooth connectivity settings on the mobile
phone. Ensure the phone’s Bluetooth capability is on.
3.
Search for the BlueTunes2 device. Select/pair with the
BlueTunes2 device. Enter the passcode/PIN 8888
.
(1)
4.
When a telephone call is made to the mobile phone, any
music/audio streaming to the headset from the PC is
paused, and the phone call received in the headset. When
the phone call is completed/rejected, any music/audio
streaming is resumed.
Note:
(1)
If the mobile phone pairs with the wrong Bluetooth device,
clear/edit the phone’s list of paired Bluetooth devices, and
search again.
CS-110826-UGP1
© CSR plc 2006 Page 3
6. Insert headphone MIC jack here.
5. Insert headphone speaker jack here.
1. Choose between the on-board antenna
(“ANT”) or the SMA RF connector
(“CON”) using this slide switch. Set to
“ANT” for normal operation.
2. Connect the Lithium/Ion polymer
battery here.
3. Set this switch to “MIC” to use the
microphone on the supplied headphones.
4. CSR recommends charging the battery
for two hours prior to first use. To charge,
connect USB cable to USB/Charge port
on PCB and USB port on PC. Ensure that
the power switch is in the “ON” position.
1. Turn the power on.
2. Press the PWR button for five seconds.
3. Red and blue LEDs flash quickly together.
The device is ready for Bluetooth pairing.
BlueTunes2 Stereo Headset
Quick Start Guide
3. Set this switch to “AMP”
