CSI CSI-DSP85-C, Installation Manual

Page: 18 / 39

- 19 -
When login is complete the user is brought to the system status page. The links on the page are
activated by clicking on them.
Web based GUI Session
Primary access to the repeater is gained using a LAN connection and a web browser program
such as Firefox by Mozilla, or Internet Explorer from Microsoft. The repeater ships with the
default IP address of 192.168.1.100, but it can be changed later if required.
If connecting directly to the repeater from a laptop or PC with a crossover CAT-5E cable or
over a LAN the user types the IP address of the repeater into the browser address line to
connect.
(Note: Most users will need to update the TCP/IP settings on their computer to enable
connection to a host that has a static IP. Select “Use the following IP Address” and enter the IP
Address as follows: 192.168.1.x, where “x” = any number from 2 to 254 inclusive other than 100.
The subnet mask is 255.255.255.0. Questions pertaining to these settings should be referred to
the user’s IT department or you may refer to the Additional Tips section at the end of this
manual.)
When connection is made the user will be prompted for a user name and password.
For the purpose of the GUI session, the default user name is dualband and the password is
csi1234 . This can also be changed as required. Internet access is not required to use the
GUI. (Note: If you are connecting using a laptop, verify that your Ethernet port is powered.
Some laptops will not allow Ethernet connection when on battery power. If this is the case
with the laptop you are using you will need to plug it in or update the power settings.)
System Status: