Instruction Manual
Art–Nr.: C140560
Seite
4
TX240 Professional-Duo-Touch
CS-ELECTRONIC
www.cs-electronic.com
2. Connection
The following describes the action process of the charger, in order to lithium polymer battery
charging program as an example.
1) Connecting power
You cab attach TX240 directly to a 11 – 32 V output power supply via the XT60 input cable.
2) Connecting the battery
Important!!! Before connecting a battery it is absolutely essential to check one last time that you
have set the parameters correctly. If the settings are incorrect, the battery may be damage, and
could even burst into flames or explode. To avoid short circuits between the banana plugs,
always connect the charge leads to the charger first, and only then to the battery. Reverse
3) Balance Socket
The balance wire attached to the battery must be connected to the charger with the negative
marking. Take care to maintain correct polarity! (See the wiring diagram below.)
Ensure to connect the battery to balance port when charging LiPo, LiIon, LiFe and LiHV
battery under balance mode.
WARNING:
Failure to connect as shown in this diagram will damage this charger. To avoid short circuit
between the charge lead always connect the charge cable to the charger first, then connect the
battery. Reverse the sequence when disconnecting.