Crystal DB477C, User Manual

Page: 31 / 44

31
1.
In standby, press , then press LCD displays "
TOT-X
".
2. Press [ / ] to select the desired value.
3. Press number key to confirm and exit.
CTCSS/DCS Encode and Decode
1.
In standby, press , then press to enter into CTCSS/DCS
Encode and Decode.
2. Repeat above operation to set as below:
LCD displays icon, it indicates CTCSS encode set in current
channel.
LCD displays and icon, it indicates CTCSS encode and
decode set in current channel.
LCD displays DCS icon, it indicates DCS encode and decode set
in current channel.
3. In corresponding icon, press [ / ] to select the desired
CTCSS/DCS encode and decode.
4.
Press , , or to confirm and exit.
1.
In standby, press , then press key, LCD displays " TALK--OF ".
2.
Press [ / ] to select the desired setting.
ON: Enable Talk Around
OFF: Disable Talk Around
3. Press number key to confirm and exit.
The prompting tone provides confirmation of entry, error status
or malfunctions of the transceiver. You can enable or disable this
function.
1.
In standby, press , then press , LCD displays "
BEEP--XX
".
2.
Press [ / ] to turn on/off BEEP voice prompt.
BEEP—OF: turn off voice prompt
BEEP—ON: turn on voice prompt
3. Press number key to exit and store.
This function can be temporarily used in Channel mode. Once the
radio is turned off or switched to another channel, the temporary
setting will be erased and back to initial settings
Voice Prompt
LCD Backlight
1.
In standby status, press , then press LCD displays " LAMP-
XX ".
2. Press [ / ] to select desired backlight brightness(1-32
levels).
3. Press number keys to confirm and exit.
Talk Around
By Talk Around function, you can directly communicate with other
radios in your group in case the repeater is not activated or when
you are out of the repeater range. The transceiver will transmit by RX
frequency with its CTCSS/DCS signaling.
This function can be temporarily used in Channel mode. Once the
radio is turned off or switched to another channel, the temporary
setting will be erased and back to initial settings.