Crystal Vision
Hardware installation
REMIND-E User Manual R1.1
7
15/05/2008
Soft key F2 LED will be illuminated. Pressing F2 will cause brackets to be inserted before
and after the message and the ENTER soft key LED to illuminate. Rotating the rotary
shaft control will change the message from <disabled> to <Enabled>.
DHCP enable menu
Press the ENTER soft key to confirm the selection. To enable DHCP mode the REMIND-
E will require a reboot. When requested to reboot rotate the shaft control to show the
reboot menu and press the F2 soft key. You will then be requested to confirm that you
wish to reboot the REMIND-E by pressing the F3 soft key.
REMIND-E will now briefly indicate that it is rebooting after which the panel will blank
before restarting in the home menu. To confirm that the new IP address is in place enter
the Stats menu by pressing the F4 soft key and scroll the rotary shaft control to show the
IP address status.
Scanning for frames
Pressing the F1 soft key will enter the scan menu. The user will then be invited to press
the F2 soft key to initiate the scan. On completion of the scan the number of frames found
will be reported and a list of their IP addresses or if named their names will be available.
Rotating the shaft control will scroll through the address information.
Available frames
Note:
The list will be compiled in the order that the frames answer the pole request, which is
likely to vary with subsequent poles.
Once a frame has been selected from the polled list the frame controls are initiated by
pressing the Enter key. At this point the REMIND-E will effectively become an active
control panel for the selected frame and will display the last page accessed in that frame.
Tip:
To return to the REMIND-E home menu at any time press the DEVICE followed by the
Up Arrow soft keys.
