Crystal Vision
Introduction
Crystal Vision
Using the front control panel
Navigating the display
The functions assigned to control panel keys are dependent on the card
selected for control, and the panel mode. The following list illustrates the
functions when controlling the DACA214:
•
DEVICE – enters Device menu to select a card or card to control /
enter Panel setup when held down during power up / shows frame
status when pressed from Statesman mode
•
CAL – Enter or leave Statesman mode / enter panel diagnostics
mode when held down during power up / updates the display
•
Asterisk – enters board rename menu from the Device menu
•
F1 to F4 – soft keys, function assigned within each menu
•
HOME – moves the display to the home menu
•
ENTER – accept current selection
•
Upward arrow – used to move up the menu structure / enter lock panel
menu from the Device menu
•
Rotary control – shaft encoder used to select options or variable data
Note:
Please refer to the Crystal Vision Control Panel manual for details of
the Panel Setup, Lock Panel and Diagnostic menus.
Updating the display
The values displayed on an active front panel are only updated when an
adjustment is made and when changing menu level. If mode changes occur
through the use of Statesman, card edge controls or through automatic
response to the input video signal, the text displayed on the active front panel
will not be updated immediately. If necessary, press CAL to update the
display.
The DACA214 menu structure
The main top-level menus are obtained by pressing the F1, F3 and F4 keys from
the HOME menu. Menu keys are illuminated when active and when further
menus are available. The three top-level menus are:
•
STATS (Status) – press F1
•
SWTCH (Switch) – press F3
•
CNTRL (Control) – press F4
The following chart shows the available menus. The actual menus available
may vary slightly as DACA214 software is updated.
DACA214 User Manual R1.9
11
04 February 2019