Crystal Vision
Introduction
Crystal Vision
Using the front control panel
3 Using the front control panel
This operational guide assumes that the panel has been setup according to
the Panel setup procedure described in the Crystal Vision Controls Panel
manual.
Note:
It is
ESSENTIAL
that the Panel setup procedure is followed and any
old or unknown passwords cleared prior to using the panel for the first
time.
At power up, the two line 20-character screen will display ‘Crystal Vision’
followed by the firmware version number for the control panel. All eight
control panel key LEDs will illuminate.
The Crystal Vision control panel start up display
'Control Panel' then briefly replaces the version number display.
If the control panel firmware has been updated for Statesman control (version
1.5.0 or higher), Statesman Mode will be entered and the message, ‘Press
CAL to Exit’ will be displayed and the CAL LED will light.
Statesman mode is entered by default
DACA214 User Manual R1.9
9
04 February 2019