!
24
Timed thermostat mode( Closed fires Only)
This mode enables the various day, night and frost thermostat modes to be set on a program timer. The
control will work as a thermostat switching between the day, night and frost temperature settings in line
with the program set.
The set up of the timer will be shown by a demonstration.
To set up the timed thermostat to be at 24 C from 06:00 to 09:00 then drop to 18 C from 09:00 to 15:30 and
then 24 C again from 15:30 until 23:30 and then to protect from frost a 5 C setting between 23:30 to 06:30
the next day from Monday to Friday this is what you would do:-
Hold handset to unlock – press set and hold until a beep and release. Press MODE button until the timer
symbol is flashing on the top of the display – press set to enter the time mode – Mo is flashing so it is
already set for Monday- press SET and release now press the + and – buttons to make the time of day read
06:00( note the steps are in 15 minutes steps) – press SET and release- press + and – to make the next
symbol show a flashing sun symbol- press and release SET- as Mo is flashing press and release SET again
enter the next time of 09:00- press and release SET- change the flashing sun symbol to a flashing moon
symbol by pressing and releasing the + and – buttons then press and release SET again to store the moon
setting (18 c)- continue this until you have entered each time and temperature change required for each
day.
To put the fire into thermostat timer mode press and release the mod button until the thermostat and timer
symbols are displayed on the display at the top. Press and release the “SET” button and the control will
now run the timed program set up in the memory.
To adjust any time setting in the memory re enter the timer program setup mode (by pressing SET and
then MODE as described above). Then press set to make the time flash. Now holding the + button advances
the display to the next setting and so on throughout the program. Amend the appropriate setting and when
finished do a long press of the SET button to exit the program mode.
To rest the whole timer program in the memory:-
Hold handset- press set- press mode until SETUP is flashing- press SET to enter SETUP- press SET about
8 times until CP0 is flashing on the display- use the + and – buttons to change the display to CP1 – press
SET – press SET again and the display will return to standby Manual mode and the timer setting have
been completely removed for the timer memory.
