!
23
Hold handset and press and release the mode button several times as necessary until the display has a
thermometer symbol flashing at the top of the display. Press the set button to enter this mode.
Press the set button again to see the temperature setting that is set and the mode (the default is 24 C ) and
on the left of the display is a sun symbol showing it’s the day temperature.
If a different set temperature is required, while the display is showing this set temperature , press the + and
– buttons to alter the setting. When finished either press set or leave and after a few seconds the new setting
will be accepted and the display will return to the time of day screen.
On the anniversary of the net minute of the clock, the set temperature will be compared to the actual
temperature displayed on the handset(i.e. the room ambient temperature around the handset). If the room
temperature is higher than the set temperature the fire will not light until the room has cooled to below the
set temperature. The fire would then automatically turn itself on when the room is cooler than the set
temperature and down and off if necessary when it is hotter than the set temperature.
(Note- when the set temperature is reached while the fire is in operation, the fire reduces the burner
power level each minute until the burner is off. The pilot (if fitted) will remain on for a further 30 minutes
and if the set temperature is still too high , the pilot will then also extinguish. When the set temperature is
higher than the actual temperature , the fire will automatically light and go to the full burner rate to reheat
the room back to the set temperature.
Note: If at any time the power button is operated during Thermostat mode, the control will cancel any
thermostat operation and return the control to manual mode.
For ease of setting there are two other modes that can be selected as stated above. Night mode (moon
symbol) and frost protection setting (a snow flake). These can be selected (and adjusted if necessary) by
pressing set then mode while in thermostat mode. Pressing mode button toggles through from day to frost
modes. The purpose of these settings is to help your fire to automatically protect you home against
becoming too cold if there is a sudden change in the weather. The control must be left in the appropriate
mode for this to function.
Note: As stated in an earlier section, snooze function can also be operated in conjunction with thermostat
mode. The thermostat symbol and the Zzz symbol will be on together when in this mode.
Thermostat mode for open fires
This is the same as for closed fires except that :-
The fire will not ignite automatically and it will only regulate between minimum and maximum burner
setting. The fire is lit manually by the remote control and then you enter thermostat mode as described
above and set the temperature. When no longer requiring thermostat mode. Turn off the burner as
described above and the handset returns to manual mode.
