EB30-2R OPERATING INSTRUCTIONS
Page 18
PROMPT SHEET
–
photocopy this page and use as a guide when testing.
Enter details onto the PC (if connected) or press WGHT to enter vehicle weight
RESET
the system by pressing
2 nd
and then
STOP
First Axle
Drive the first axle into the rollers.
Foot Brake:
Press
START
key to start both roller sets. Allow the wheels to
centre and press
STOP
Press
START
key to start only the left roller set. Apply footbrake smoothly until the
wheel stops. Once acceptable reading has been obtained press
OK
to store.
Press
START
key to start only the right roller set. Apply footbrake smoothly until the
wheel stops. Once an acceptable reading has been obtained press
OK
.
Press
START
key to start both roller sets. Do not apply any brake force. Wait for
display to show either the bind value or symbol “--” .
Apply a brake force of about 500 kgf and hold pedal steady. Press
OVAL
key, wait
6 second approx. When DDsp shows BAL, apply footbrake to about 90% of
maximum force measured above hold and slowly release. Press the
STOP
key.
Press
OK
key to save the results.
Secondary Brake test:
Press
SEC
key
Press
START
key to start only the left roller set. Apply secondary brake smoothly
until the wheel stops. Once acceptable reading are obtained press
OK
to store.
Press
START
key to start only the right roller set. Apply secondary brake smoothly
until the wheel stops. Once an acceptable reading has been obtained press
OK
.
Parking brake
- ONLY class V!
Apply the Parking Brake and press
PARK
key to start the test.
Press
START
key to start only the left roller set, wait 3 seconds, press
OK.
Press
START
key to start only the right roller set, wait 3 seconds, press
OK.
Next Axle:
Press
AXLE
followed by
DOWN ARROW
key to switch to next.
Print results:
P
ress
key to print the test results.
