Crux Interfacing Solutions • Chatsworth, C
alifornia
phone: (818) 609-9299 • fax: (818) 996-8188 • www
.cruxinterfacing.com
rev.020520
2 of 3
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
DIP SWITCH SETTINGS:
INSTALLATION INSTRUCTIONS:
INSTALLING THE CDR-02 CAMERA AND CABLE
1. Remove the rear panel lip.
2. Drill a 5/8 inch size hole in the available location.
3. Fish the wires thought the drilled hole and through the pass through into the trunk/cargo area.
4. Route the wires towards the radio and make the power and video connections. For powering up the camera, use the 12V
OUTPUT (White Wire). (See Wiring Diagram on page 1)
5. Connect the camera ground wire to chassis ground. If video noise is present, we recommend grounding the camera
directly to the BLACK wire on the RVCCH-75C T-harness.
6. Test the camera before re-installing the radio.
CODING THE RADIO FOR A REAR VIEW CAMERA
The radio has to be coded to accept a reverse camera. Please follow the coding procedure below:
1) Turn key off and remove the key from ignition.
2) Open the driver door then close it (make sure all doors, lift gate and hood are also closed).
3) Look at the module and wait for LEDs to turn off then disconnect the module.
4) Before plugging back the module, turn all DIP switches to ON then OFF.
5) Set DIP switches 1 (if permanent VIM is desired), 2 and 6 to the ON position.
6) Reconnect module and wait for the LEDs to turn off.
7) Start up engine and the coding operation is complete.
8) Put the gear in reverse to test the camera.
FORCED VIEW OF REVERSE CAMERA
The Force RVC is used to view the back-up camera when the vehicle is
not in reverse gear. Allows you to view what is in the back while driving.
To activate this feature, make sure that DIP 4 is set to ON. Press the center
button once on the left hand side steering wheel control (located behind the steering wheel).
NOTE: The camera is defaulted to power down after 10 seconds.
DIP SWITCH FUNCTIONS:
DIP 1 = Video in Motion Activation ON / OFF
DIP 2 = Rear View Camera ON / OFF
DIP 3 = Not Used
DIP 4 = Forced RVC ON / OFF
DIP 5 = Defaulted to OFF*
DIP 6 = Defaulted to ON*
RVCCH-75C
Rear View Integration Interface with VIM
for CHRYSLER, DODGE & JEEP
*DIP 5 & 6
If the radio is having turn-on issues, please try the following:
Attempt 1: Set 5 & 6 to ON
Attempt 2: Set 5 to ON and 6 to OFF
Attempt 3: Set 5 to OFF and 6 to ON
1 2 3 4 5 6
ON
