FlashTiming FT-FAT200 Start-Up Instructions
These instructions will guide you through the initial setup of your
FT-FAT200
system. Run
Setup200.exe to install the application. Connect the USB radio to the computer as shown in Step
2a before running the installer. Install the software from the CD or download from the website:
Go to FlashTiming.com, select Downloads, Updates and then FT-FAT200 Update.
Then, follow these instructions to set up the system:
1. Connect the camera to the capture computer
a.
Attached the right angle antenna to the back of the camera cover.
b.
Attach the power cord with the power supply to the black Trendnet POE Switch . Plug the
power cord into a standard wall outlet.
c.
Connect the camera to the Trendnet POE Switch with a Cat6 Ethernet cable. The system
comes with an extra Cat6 Ethernet cable for testing purpose. Plug one end of the cable
into the Ethernet port on the back of the camera cover. Plug the other end of the cable
into
one of the 4 ports on the back of the switch labeled POE
.
d.
Connect the POE switch to the computer with one of the provided Ethernet cable. Plug
one end of the cable into any port on the back of the POE Switch. Plug the other end of
the cable into the Ethernet port on your computer. You must have a 1Gbit Ethernet port
for the camera to obtain 200 frames per second.
You can connect your other computers to any of the ports on the POE Switch.
The capture computer is the only computer that needs to have a 1Gbit Ethernet port.
The other computers can have a 100Mbit Ethernet port.
2. Connect the USB radio to the computer
a.
Use the USB cable to connect the USB radio to the computer
b.
Attached the right angle antenna to the USB. Use the external antenna if in a metal
press box or in another setting that may impede the radios from communicating.
