Below is an example of how to remove the radio of a Cadillac for reference. Other models may have a
different way of removing the radio.
1.
Remove radio to gain access to the rear connectors. Be careful not to break the mounting clips on the radio trim
bezel. Please see pictures above for reference.
2.
Unplug the radio connector, USB and mini USB from radio.
3.
Plug the male power connector to the harness provided in this kit. Please note that the CUE system will have a
16-pin connector and the MyLink System will have a 10-pin connector. A harness for each system is included in
the ACPGM-80V kit.
4.
Plug the 6-pin Molex connector of the harness being used to the CAN box included in the kit.
5.
Plug male mini USB connector from the vehicle into the female mini USB port of the LVDS cable provided.
6.
Plug the male mini USB of the LVDS cable to the radio.
7.
Reconnect the USB and any other connector that was unplugged during removal of the radio.
8.
Plug the audio 3.5mm Aux Cable into the interface and route to the
vehicle’s OE Aux
input jack.
9.
Install the camera (not included) to the rear of the vehicle and run the cable towards the interface location.
10.
Plug the camera RCA connector to the red RCA of the video harness.
11.
Use the green wire from the CAN Box power harness to power the camera.
12.
Use the two extra video inputs and audio cable to connect other AV sources.
13.
Test the system for functionality before reinstalling the radio. Put the vehicle in reverse and verify that the
camera image is seen on the screen. For touch screen radios, press and hold anywhere on the screen for 3
seconds to toggle between the AV inputs. For non-touch screen radios, press the MENU button to toggle
between AV inputs.
14.
Reverse the order of installation to put back the radio and all the trim.
Summary of Contents for ACPGM-80V
Page 2: ...rev 030518 2 8...
