1.
Remove the factory radio from the dashboard and unplug the connectors behind the radio.
2.
Mate the T-Harness connections to the factory connectors. (Make sure all connectors are properly
seated into the interface and into the radio.)
3.
On the CAN Module, set DIP switch #4 to ON to enable the AV Input.
4.
Connect the audio and video source to the female RCAs on the AVICH-03 T-Harness.
5.
Switch to the new AV input by pressing the BACK button on the radio or the middle button on the
steering wheel controls behind the left side of the steering wheel. (See page 3) (If the radio does
not have a BACK button use the GREEN wire option to toggle the AV source by connecting it to
+12V. We recommend using a toggle switch to use this feature.)
6.
Test the system before putting back the radio.
Make sure the DIP#4 is set to the ON position. This sets the programming to the vehicle.
NOTES:
1. Set DIP#6 to ON if you experience the radio freezing or not responding properly.
2 / 3
rev.113018
DIP 1 OFF Not Used
DIP 2 OFF Not Used
DIP 3 OFF Not Used
DIP 4 ON
AV Input Enable
OFF
AV Input Disable
DIP 5 OFF CAN Termination Radio Side
DIP 6 OFF CAN Termination Car Side