17
Hopper and Components
General
The hopper on the 850 cart is constructed of sheet metal. All carts are equipped with a grain flow
control door (also referred to as a slide door) mounted on the bottom of the hopper. This door and
the hydraulics required to operate it are considered part of the hopper assembly. In addition, the
auger transport saddle and the lighting kit are considered part of the hopper.
Do not store your cart with grain or other material left in the bottom. The hopper should be cleaned
before storing and the drain door located at the bottom of the auger tube should be opened to
permit water drainage. Repair and paint any damaged areas on the hopper.
Grain Door (Slide Door)
The grain flow control door is hydraulically operated from the tractor. It is used to close off or control
the grain flow to the auger. It is recommended that this door be completely closed when pulling the
cart in the field. This will prevent grain from packing into the bottom of the auger. This could cause
possible damage to the drive system on the PTO models or the hydraulic motor to stall on the
hydraulic driven models.
An indicator is located on the front of the cart hopper to show whether the door is opened or closed.
The door can also be used to regulate the amount of grain going to the auger. This may be useful
when loading grain drills or other containers where only a limited amount of grain is needed. In such
cases, DO NOT simply run the auger slower as this could cause damage to the drive system.
Instead, use the grain-flow control door.
Before using your cart for the first time, make sure this door is opening and closing properly. If it is
not, you will not be able to unload the cart.
Auger Saddle
The auger transport saddle is located on the left back side of the cart. Always fold the auger back
into the saddle when transporting the cart. Make sure the auger rests firmly in the saddle.
CAUTION:
Keep everyone clear of the cart while folding or unfolding the auger.
Item Part No.
Description
1
969899
Auger Saddle
2
229278
Back Up Plate
3
229260
Back Up Plate -Short
