Finally
Start assembling the covers again to finish the work. Make sure that no screws or clips are left over,
Reconnect the battery/power source terminal.
Finally, it´s time to play some good music and enjoy!
Running-in time
Allow the component kit to play for at least 15-20 hours in order to
perform at its possibly best. This run-in can be made with tone
sweep or with just music.
Start at a moderate volume and increase the volume step by step
during the running in period. After the 15-20 hour run in session the
performance and characteristics will be in the correct condition.
DLS Support
For technical assistance, ask your car audio dealer where the product was sold or the distributor in your country. You
can always contact the DLS Helpdesk in Sweden at e-mail: [email protected]. Information can also be found on our WEB-
site www.dls.se. We follow a policy of continuous advancement in development. For this reason, all or part of the
specifications and designs may be changed without prior notice.
Connect the crossover with the PnP connector. Use the other adhesive foam to secure the crossover and
cables
The yellow cables are a jumper for decreasing the tweeter level 4dB
6
Summary of Contents for DLS CRUISE CRPP-2.6
Page 1: ...User manual Seat Skoda VW...
Page 9: ...Impedance VS Frequency 8 168 5 R6 5 5...
Page 12: ......
