3
Once the Flexi-Fix
wall plates are
secured to the
wall, place the
Riser Rail brackets
over each of the
Flexi-Fix wall
plates and secure
by tightening the
grub screw with
the hex key
provided.
DO NOT
OVERTIGHTEN.
WHEN USING ADHESIVE FIXING METHOD
24
LEAVE
HOURS
C
(
)
i
CHECK
LE
VEL
Assemble wall plate, alignment
guide and locking nut as shown.
Remove backing from adhesive
pad on alignment guide.
Please refer to Important Adhesive Information at
the front of this leaflet before proceeding
Place assembled wall plate in
desired location and press firmly.
Cut the end of the sachet and apply
a generous amount of adhesive to
the back of the wall plate as shown.
(Each sachet has sufficient adhesive
for two wall plates).
Carefully place the wall plate over the
alignement quide and allow the rotation
of the locking nut to secure the wall plate
in position.
DO NOT PRESS IN POSITION!
Leave the adhesive to set for
24 Hours
Undo locking nut and remove wall
plate leaving the alignment guide
stuck to wall
Sufficient
adhesive must be
applied to give a
uniform thickness
of approximately
1.5mm when the
wall plate is
positioned
against the wall.
Before starting
ensure all surfaces
are clean and free
from dirt and soap
residue,
particularly if
adhereing to tiled
walls.
SWR 060 R03
TIP!
To ensure the
Riser Rail is
vertical, mark the
wall using one
wall plate and
using a spirit level,
mark the second
plate whilst being
careful not to
exceed the
recommended
centre distances.
Step 3
Place the square
nut into the recess
in the back of the
wall bracket.
Partially insert the
grub screw into
the threaded hole
in the square nut.
Image shown for reference only - grub
screw previously fitted into wall bracket.
AM1824## /
AM1825## /
AM1826##
Max Distance =
720mm
AM3000## /
AM3020##
Max Distance =
600mm
