CENTRES
A
WHEN USING EXISTING HOLES
40mm
Drill holes
i
CHECK
LE
VEL
WHEN DRILLING NEW HOLES
30mm
Centres
B
AM1824## /
AM1825## /
AM1826##
Max Distance =
720mm
TIP!
To ensure the
Riser Rail is
vertical, mark the
wall using one
wall plate and
using a spirit level,
mark the second
plate whilst being
careful not to
exceed the
recommended
centre distances.
NOTE
Wall plugs supplied
are suitable for a
solid wall fixing
only.
For cavity walls or
plasterboard use
specialist fixings
available from all
good DIY stores.
1
Remove your old riser rail and make sure you clear the existing screw holes
of any debris.
2
Fix your Flexi-Fix brackets to the wall using one of the three methods
below.
Remove old wall plate.
(PLATE SHOWN FOR
REFERENCE ONLY.)
CAUTION!
Ensure holes in
the wall are
sutiable for
re-use.
It may be
necessary to
drill new holes.
Using a pencil mark
the screw hole
centres for the wall
plates 30mm apart.
Insert wall plugs into the wall and fix
the wall plates tightly into position
using screws supplied.
Flexi-Fix Wall Plate will fit
existing hole centres of -
Max - 34mm apart
Min - 15mm apart
SWR 060 R03
AM3000## /
AM3020##
Max Distance =
600mm
