CXM2000
影院扬声器优化/监听系统
CXM2000 Monitor and Crossover System
Operation Manual
page 11
操作手册
4 Setup
(continued)
4.安装
（接上一页）
4.4.3 Connecting the CXM2000 output to amplifier
Use the HD-15 cable to connect the Crown DSi series or XLC series amplifiers to the CXM2000. Please refer to
figure
4.4
to connect the CXM2000 to the amplifiers in bi-amplified cinema speakers system and
figure 4.5
in passive cinema
speakers system.
If the CXM2000 is connected to an amplifier with XLR connector, please refer to “Appendix I. Pin Definition” on page
18 to select the correct interface converter.
4.4.3.连接至功放
使用15针接口线缆连接Crown DSi系列或XLC系列功放的输入接口和CXM2000的输出接口。如
图
4.4所示为连接CXM2000至双功放通道驱动式扬声器系统的各个声道功放，图4.5所示为连接
CXM2000至被动式扬声器系统的各个声道功放。
若要连接至XLR接口的功放，请参看第18页的“附录一、引脚定义”选择合适的转换接口进行
连接。
Figure 4.4
Connect the CXM2000 to bi-amplified cinema speakers system
Figure 4.5
Connect the CXM2000 to passive cinema speakers system
图4.4 连接CXM2000至双功放通道驱动式扬声器系统
图4.5 连接CXM2000至被动式扬声器系统
L-Bi-amp
L&R-Passive
R-Bi-amp
Null-Passive
Sw1
C
Sw2
Ls/Rs
Bsl/Bsr
INPUTS FROM PROCESSOR OUTPUTS
RS-232
Firmware update
OUTPUTS TO POWER AMPLIFIER INPUTS
Speaker
1-4
System 5-8
1 2 3 4 5 6 7 8
ON
230
POWER AMPLIFIERS
CXM2000
L Channel
R Channel
C Channel
Bsl&Bsr Channel
Ls&Rs Channel
SW2 Channel
SW1 Channel
L-Bi-amp
L&R-Passive
R-Bi-amp
Null-Passive
Sw1
C
Sw2
Ls/Rs
Bsl/Bsr
INPUTS FROM PROCESSOR OUTPUTS
RS-232
Firmware update
OUTPUTS TO POWER AMPLIFIER INPUTS
Speaker
1-4
System 5-8
1 2 3 4 5 6 7 8
ON
230
POWER AMPLIFIERS
CXM2000
L&R Channel
Ls&Rs Channel
C Channel
SW1 Channel
SW2 Channel
Bsl&Bsr Channel
L:
R:
C:
Ls:
Rs:
Bsl:
Bsr:
SW1:
SW2:
Left Channel
左声道
Right Channel
右声道
Center Channel
中置声道
Left Surround Channel
左环绕声道
Right Surround Channel
右环绕声道
Back Surround Left Channel
左后环绕声道
Back Surround Right Channel
右后环绕声道
Low Frequency Effect Channel 1
次低频声道1
Low Frequency Effect Channel 2
次低频声道2
