Crown CT33131, Original Instructions Manual

Page: 16 / 64

16
English
The manufacturer reserves the possibility to introduce changes.
• In order to improve working results you may use ac-
cessories (rulers, templates, etc�), in this case move
the cutting torch, dabbing its sidepiece on a template -
you'll achieve the required shape�
• After completion of the work, allow the machine to
cool down, switch it off, disconnect the cables and air
delivery hose, and turn off the compressor�
Machine maintenance / preventive meas-
ures
Before carrying out any works on the machine it
must be disconnected from the mains.
Condensate drain (see fig. 8.2)
The condensate should be regularly drained from pre-
cipitation tank of pressure reducting valve
26
� Put a
reservoir under precipitation tank of pressure reducting
valve
26
, push button
46
and wait until all the conden-
sate is drained, and then release the button
46
(see
fig. 8.2).
Electrode and nozzle replacement (see fig. 5-6)
Regularly check the condition of electrode
40
and noz-
zle
38
�
• If the crater depth on electrode
40
radiating surface
achieves 1,5 mm, electrode
40
should be replaced
(see fig. 5-6).
• If nozzle
38
opening is malformed or enhanced in
diameter, nozzle
38
should be replaced�
• Replacing electrode
40
and nozzle
38
at the
same time is recommended: it will extend their ser-
vice life�
Cleaning of the machine
An indispensable condition for a safe long-term ex-
ploitation of the machine is to keep it clean� Regularly
flush the machine with compressed air thought the
vent holes 1 �
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.crown-tools.com �
Transportation of the machine
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging�
Environmental protection
Recycle raw materials instead of dispos-
ing as waste.
Machine, accessories and packaging
should be sorted for environment-friendly
recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�