10
There is a exit delay prior to the system being armed. During this delay time you can
leave the premises. At the end of the procedure. the ARMED indicator lights up to
indicate that the system is armed, and the system message is displayed. (The indicators
may go out after a few seconds, depending on the installer's setting).
Quick Arm
When enabled by the installer, press <
ARM
> to arm the system.
During this delay time, a slow beeping is heard to indicate that the system is not armed
yet and reminds you to leave the protected area..
If you must disarm the system during the exit delay, press <
ARM
>.
Disarming the System
Enter
User
’
s code
and press <
ENTER
>.
The following system message is displayed:
Stopping Alarms
Enter
User
’
s code
and press <
ENTER
> to stop alarm any time.
How to Arm the System when Staying Home
Arming the System in Stay Mode
This type of arming is used when people are present within the protected area. At night
time, when the family is about to retire , perimeter zones are protected, but not the interior
zones. Consequently, interior movements will be ignored by the system.
When the system is Ready,
press <STAY>
and the system prompts you to
enter user
code,
and then <
ENTER
>.
Quick Stay
When enabled by the installer, press <
STAY
> to arm the system.
During exit delay you can leave the premises. If you wish to stay or that no one will enter
the protected premises, you may cancel the Entry/exit delay by pressing the <
ENTER
>
key. The slow beeping stops and the system is immediately armed.
At the end of the procedure, the Stay indicator lights up to indicate that the system is
armed and the system message is displayed. (The indicators may go out after a few
seconds, depending on the installer's setting).
Areas Armed
A -
Areas Disarmed
A -
Enter Code
****
Areas In Stay
A -
www.msealarms.com.au
All manuals and user guides at all-guides.com
