INSTALLATION INSTRUCTIONS
Remove all outer packing and carefully
Please do not lift the product by the plastic diffusers as this may
cause damage to your product.
check the product is in perfect condition.
The mirror is supplied with a protective film
DO NOT remove this until installation is
complete.
x6
x6
x2
IMPORTANT
The product must be installed with a minimum distance of 150mm
between the infrared sensor and an adjacent wall surface, countertop
or other object to ensure correct function of the sensor.
It is recommended that walls are fully tiled/finished before installation. This ensures that the product is installed flat to the wall face and
allows product to be easily removed if required in the future.
STEP 1
Offer the mirror up to the desired wall location considering the safety zone
requirements. Using spirit level ensure the mirror is level and upright and
mark top of mirror. Using a soft pencil mark carefully the 2 fixing points.
WF6060 X=200mm A=170mm
MEA6080 X=130mm A=410mm
MET6080 X=590mm A=35.5mm
STEP 2
Carefully drill the required holes and insert wall plugs. Prepare the power
supply. Note screws and plugs supplied are suitable for solid walls only.
ENSURE THAT THE MAINS VOLTAGE SUPPLY TO WHICH THE
MIRROR IS BEING CONNECTED IS ISOLATED
Carefully feed the mains supply cable through the rubber grommet in the
mirror frame. Hold the mirror frame in the correct position, insert screws
and screw into wall plugs, ensure they are secure and the electrical mains
supply cable free from obstruction.
2 persons
Ph2
Ø8 mm
WF6060
MET6080
MEA6080
MIN
150mm
Sensor switch
Touch switch
Touch switch
2.
A
Xmm