Features
1.
31 Band Equalizer, 1/3 Octave
These 31 slider pods adjust the frequency indicated up to +12dB.
2.
Range
Depressing this button switches the slider pods to +6dB or +12dB of adjustment.
3. +6dB, +12dB Range and Power Indicator
These LED’s illuminate indicating the range setting of the equalizer and the power up of the unit.
4. Bypass
Depressing this button allows you to bypass the equalizer section.
5.
Bypass
LED
This LED illuminates indicating the bypass button is being utilized.
6.
Clip
This indicator illuminates when the output level is reaching the maximum of 8VRMS and the output is clipping.
7.
Subsonic Filter
This knob adjusts the variable 12dB subsonic filter to eliminate energy wasting ultra low frequency resonance
caused by preceding components as well as picked up through cables.
8. Output
Level Control
This adjusts the output level voltage of the CFQ31M to match the input level of the next processor or amplifier.
9. Input
Level Control
This gain control is used to adjust the input sensitivity of the CFQ31M to match the radio's output.
10.
¼” TRS Input
This input accepts balanced line signal from the source unit utilizing TRS (Tip, Ring, Sleeve) style connectors.
11.
XLR Input
This input accepts balanced line signal from the source unit utilizing XLR style connectors.
12.
¼” TRS Output
Use this output if the next component accepts balanced line TRS style connectors.
13.
XLR Output
Use this output if the next component accepts balanced line XLR style connectors.
14.
RCA Line Level Input
This input accepts unbalanced signal from the output of the source unit via RCA patch cables.
15.
RCA Line Level Output
Use this output if the next component accepts unbalanced RCA patch cables.
16.
Chassis Ground
This switch is used to disconnect the signal ground from the main chassis ground if noise is present due to a
possible ground-loop.
17. Power Input Terminals
B+
: connect to the vehicle's positive 12 volt supply (+12 volts DC)
B-
: connect to the vehicle's chassis (-12 volts DC)
R
emote turn-on : connect to the remote turn-on lead of the source unit
D
elayed
R
emote turn-on : connect to the remote turn-on leads of all signal processors and amplifiers
following the CFQ31M. This will delay the turn on of these units by 2 seconds after the source unit
is powered up.
18. Fuse
This 3amp fuse will help protect the CFQ31M from damage in case of a short.
