CCpilot X1400
Product revision: 1.0
Technical manual
2022-12-20
www.crosscontrol.com
7
3.
Installation
Install the device in such a way that is considered safe and does not expose any unnecessary
stress to the unit. In this section, some recommendations are made regarding installation.
3.1.
Connecting to Power Supply
This instruction addresses vehicle installations, but the principle is the same for other types of
installations. See also the description of the pin outs for the Power Supply Connector under
•
Carefully follow the connection instructions below. Make sure that all contacts are angled
correctly and that they do not have to be forced but lock gently and pliant.
•
GND (pin 2 and 5) is connected to the vehicle’s ground.
•
Battery (pin 1 and 4), i.e. the computer’s power supply (+24 VDC), should be connected
directly to the vehicle’s battery through 10 A fuses (F1). For 12V systems F1 shall be at
least 15A. Wire gauge shall be dimensioned with respect to cable length, supply voltage
etc.
•
The ON/OFF (pin 3), i.e. the computer’s on/off signal is connected via the vehicles turnkey
signal or an external on/off switch (S1). If the vehicle has a main power switch the
computer shall be connected after it,. The maximum allowed input current for the on/off
signal is 2.5 mA. The fuse F2 fuse rating and wire gauge shall be dimensioned for the total
switch current.
10/15 A
