CCilot XA and CCpilot XS
Product revision: 0.12
Software guide
2018-03-19
www.crosscontrol.com
19
Long press - ON/OFF button -
adjust the unit behavior when pressing and holding the On/Off
button.
ON/OFF signal
- adjust the behavior of the On/Off signal through the power connector. The time
setting adjust how long the signal must stay low before the device reacts to the signal.
Unit start-up
makes it possible to select if the unit shall respond to start-up from both the on/off
button and/or the on/off signal in the power connector, or if it shall be configured to start up
directly when supply voltage is applied.
TBD/Suspend mode
is used for activating automatic transition from suspend mode to shut down of
the computer. The time defines the amount of minutes the device shall remain in suspend mode
before shutting down. Setting the time value to
0
disables the shut-down feature; the device will
stay in suspended mode indefinitely, until started or until power is removed.
5.15.
Advanced
The Advanced page is used for loading new firmware
into the device and to restore settings to factory
defaults.
To update the respective firmware, make sure the
firmware file is located on the device. Browse for the
appropriate file, then press the corresponding upgrade
button and wait for the firmware update to complete.
For detailed information about how to upgrade the
firmware, please see additional documentation
specifically for firmware update.
5.16.
Telematics
The Telematics page is used for control of All Integrated
functionality such as the GPRS modem, the GPS
receiver, the Bluetooth module and the WLAN chip.
The controllability is about applying power and
enabling the specific functionality, either as one time
power cycling or as permanent startup setting.
Additionally, the GPS receiver and the GSM/GPRS
modem have additional status information and
command possibilities in their specific tabs.
